I have a problem with a custom card and the MK60FX512VLQ15.
I have a SDCARD connector. It is mapped on the pin 1, 2, 3, 4, 7 and 8 (SD1, SD0, SDCLK, SDCMD, SD3 and SD2).
The Card Detect signal is mapped to PTA4 (pin 54).
When I put a SDCARD inside, everything is ok.
The problem is when I let the SDCARD inserted.
In this case the program don't boot and if I try to program it with the JTAG mapped from PTA0 to PTA3, the K60 cannot be reach.
What am I doing wrong?
How can I correct this?
Thank you for you ranswer.