AnsweredAssumed Answered

Missing GPIO options in PE for Kinetis L

Question asked by eyaldoron1 on Nov 16, 2013
Latest reply on Nov 19, 2013 by Eyal Doron


I'm setting up a project for the Kinetis KL25 (currently on the FRDM-KL25Z board, but afterwards on a custom board), I recently upgraded PE to 10.2, and it looks as if the GPIO initialization is missing a lot of options: drive strength and pulldown resistor selection (up/down) in particular. They were all there before. Does anybody know how can I get them back?




Eyal Doron