I am new to this - followed start-up directions (I thought) and did see the drive once or twice - but can't get it back -THE LED prgrm is running, the slider sensor adjusts intensity - when I boot in Bootloader mode the Bootloader drive comes right up. I can't find any troubleshooting help or instructions other than the community.
I',m through the quick start-up instructions to where I'm supposed to copy example programs to that drive - but it's lost
Can anyone please help me? THanks,
Dave Haas
Solved! Go to Solution.
Hi,
this article gives an overview and tips:
OpenSDA on the Freedom KL25Z Board | MCU on Eclipse
and if you are going to debug your board, then this article might help:
The Freescale OpenSDA Trap: “No Device Available”, or something like that…. | MCU on Eclipse
Hi,
this article gives an overview and tips:
OpenSDA on the Freedom KL25Z Board | MCU on Eclipse
and if you are going to debug your board, then this article might help:
The Freescale OpenSDA Trap: “No Device Available”, or something like that…. | MCU on Eclipse