I'm a newbie in USB and I've to program the JM60 as a USB mass storage.
I've already used the Freescale USB Stack v4.1.1 and the JM60 is'nt recognized by windows ( XP) .
If somebody can help me he's welcome.
Please use CW10.x project, the path is like:C:\Freescale\Freescale USB Stack v4.1.1\Source\Device\app\msd\cw10\s08usbjm60.
It can work in DemoJM60 board. There is compile error in CW classic project, sorry.
thaks for your answer.
I haven't CW10 so it will be a little complicated.
ok, if you want to use CW classic, please modify the compiler option as below, after doing that the project can work.
1. Select standard setting
2. Modify the compiler option
3. After download the program to DemoJM60, we can see the device in hardware manager.
thanks a lot for your help. The program compile but my 60 stays as an unknown device and windows tell me that it's work normally
I also tried to install with the .inf file but no results.
thanks for help
I also test the board in windows XP, works fine, even needn't to install driver.
Did you try to reconnect the USB plug ? I mean plug out then plug in again.
In addition, you can try to make the board work standalone (without debugger),
Move th jumper cap in J3 to MiniUSB_VDD, then plug the USB to PC, the board will be powerd on by PC USB.
I don't work on a DemoJM Board so I Have'nt any jumper .
I tried to reconnect the USB plug and there is no result again.
If so, it's possible that the issue is caused by the board. could you show me the schematic of your board?
I'll try to get it in the afternoon
Can you give me your e-mail to send you the schematic please.
Retrieving data ...