AnsweredAssumed Answered

MCF5328 based product not getting progrmmed through Cyclone MAX BDM port

Question asked by Suhas Galgale on Oct 25, 2012
Latest reply on Nov 1, 2012 by Suhas Galgale

A new product based on MCF5328, has 26-pin BDM port, which we used for firmware development & product is now ready for production.

We want to use Cyclone Max for programming production unit, but it is not getting programmed.

Same board gets programmed with same BDM port on development system.

I have attached a schematic file with this.

Flash gets half way programed & stops. No fixed location every time.

If anybody has faced similar problem & know solution for that, please let us know.

Your will appreciate your advice.

Thanks

Attachments

Outcomes