IMX53 QSB board interfaced with the OV5640 Sensor interface, I configured boundary_camera and ov5640 driver and Boot Sequence for ov560 are configured. But OV5640 is not responding any of the I2C commands. Any one Faced this issue, kindly response.
i have same problem! , we can discuss it
Have you turned on the clock?
Thanks for Reply. For me start working. Two Problems.
1. Boot Sequence was wrong. I corrected it.
2. Hardware connection was wrong in DVDD.
Now It is responding with I2C communication.
Now I able to capture images in Jpeg. Now I am facing one issue on Interrupt Handling in IPU Block. I am able to configure only EOF DMA channels(INT-0). So i will get interrupt notification only After DMA Buffer Full. But I should get the Interrupt Notification at the End-Of-Frame, that is end-of-vsync. Any one attempt on the same. kindly response me.
Thanks in Advance.sami
How did you capture jpeg image?! With gstreamer + v4l2src?
I'm having some trouble with this too.
Retrieving data ...