Go to nxp.com
Where is this place located?
to create and rate content, and to follow, bookmark, and share content with other members.
WAIT on 908JL16
Discussion created by
on May 19, 2007
on May 23, 2007 by bigmac
Show 0 Likes
I need my 908JL16 to initialise in the wait (or maybe stop) mode until an external interrupt occured, eg. key press, SCI_rx....After works are done, JL16 turn back to wait mode.
where can I put the wait instruction?
This content has been marked as final.
Show 1 comment
(Required, will not be published)
May 23, 2007 6:11 AM
It would be usual to place the wait (or stop) instruction within the main loop of your program. When the external interrupt, or perhaps KBI occurs, processing of the ISR code should then immediately take place, and when completed, the operation will continue with the code immediately following the wait instruction.
You can then continue with other main loop operations before looping back prior to the wait instruction.
Show 0 Likes
Retrieving data ...
MPC5 software example list
Error in enumerating usb4604 to imx6sx
Clarification of GPIO1 dedicated interrupts -- overlap with combination interrupt.
Example MPC5744P PIT triggering interrupts
One coordinator allows only 8 ZEDs join zigbee network