Nigel Spon

CW 6.3 CF assembler: mac parallel load not available?

Discussion created by Nigel Spon on May 1, 2007
Latest reply on May 1, 2007 by Nigel Spon
I'm successfully using the

mac.w D0.L,D1.L,ACC0

instruction, but the parallel-load extension of this

mac.w D0.L,D1.L,ACC0,(A0)+,D2

doesn't work -- the ColdFire 6.3 assembler is claiming "too many arguments". Its legitimate as far as I can tell from the CF Programmers Reference Manual, I'm not even using the & option. Is this not supported yet?


Outcomes