I am using MQX on TWR-K60 and TWR-LCD is attached on primary side. SW1 is 10111110 and SW5 is 1111. I am not able to get input from touch pad. Not able to figure out why it is not working. Any help is welcome.
Thanks and Regards,
SW5 must be all ON. And 51JM in TWR-LCD must be reprogrammed. If 51JM is running the default application will try to drive the touch lines, so you have two options, use a USB BDM Multilink to program an 'empty' software that does nothing or using the default bootloader, program the application I posted in this thread:
That sw running in 51JM will not create any conflict with K60 driving the touch panel lines. In the theat you will find instructions to drive the panel using FlexBus (faster).
Thanks for the info. Before getting your mail, I re-assembled the tower board and i was able to use touch pad ...... :)
I've been using your posts to other's questions and your presentations to learn about tower. Thanks once again for prompt response.
Retrieving data ...