Is there an example of using the USB to interface to an FTDI usb to serial device for the Kinetis K60N512?
When I make a new project selecting USB host and CDC type and run it I get unknown devide attach event.
In MQX you have this example:
Freescale\Freescale MQX 3.7\usb\host\examples\cdc\cdc_serial\cw10\cdc_serial_twrk60n512
In bare metal USB stack you have :
\Freescale\Freescale USB Stack with PHDC v3.0\Source\Host\examples\cdc_serial
This is the block diagram of demo implementation:
Be sure you are configuring your TWR-SER for host operation.
You have demo instructions on attached manual (Appendix C)
Retrieving data ...