Hi to all,
I'm starting to debug a new hardware with a K20 device (PK20X256VLL) but I can't get connected with target device.
CodeWarrior 10.1 with all avalilable updates (1.0.1 and 1.0.2)
P&E Universal Multilink with 10pin cable
Jtag signals (CLK, TMS, TDI, TDO) and reset signal appear valid on oscilloscope during connection attempt. Power supply seems valid.
P&E Multilink seems to be recognized and blue and yellow leds lighted.
Attached snapshots of CW remote system configuration and error message.
Any suggestion? Any investigation idea?
Thanks in advance