iMX6 SoloX MAPBGA529 Orcad symbol
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How to get iMX6 solox MAPBGA529 Orcad symbol?
Thank you so much!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK,thank you very much for your reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi lin
I am afraid such design was not publicly released, suggest try to obtain
through local marketing office.
Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi igor
Thank you very much for your reply!
It should be that I understand the wrong, how should I understand the "Package Termination Count", is this not the same as the number of BGA device balls?As shown in the figure below, the Package Termination Count is 529, but the package is BGA400.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
more accurate package info can be found in i.MX6SX Datasheet
Figure 1. Part Number Nomenclature—i.MX 6SoloX:
https://www.nxp.com/docs/en/data-sheet/IMX6SXAEC.pdf
Best regards
igor