i.MX93 JTAG debugging

[lw1]

I would like to use openocd for JTAG debugging on the i.MX93, but the processor seems to be in Boundary Scan mode (IDCODE 0x0892801d rather than 0x5ba02477).

What do I need to do to switch to DEBUG mode?

Is there an openocd configuration file available?

Lothar Waßmann

[KristianH]

Hello Zhiming_Liu,

Could you send them to me too please?

Regards,

Kristian

[MIFR]

Did this patch ever get to be publicly available? Anywhere to get a hold of it?

[lw1]

I didn't get any email with an attachment. Just the notification mail from this thread.

[Zhiming_Liu]

Hello @lw1 

You need patch the openocd refer attachments in email

[lw1]

What attachment?

[Zhiming_Liu · Accepted solution]

Hi @lw1 

I have sent the attachments via email.

[_user_1011]

Hello @Zhiming_Liu 

Could You please send me the necessary OpenOCD files for the FRDM i.MX93 development board? I would like the board file as well as the file for the SoC, and any other file I would ne

FRDM-i.MX93 

[kevin225]

Could you share the openocd patch with me as well?

[Bob_NXP_user]

Hello Zhiming_Liu,

Could you send them to me too please?

Regards,

Roberto

[chmr]

Hi, please send the patches to me too.

Wouldn't it be easier to just make them downloadable on the imx93 product page, or even better, send a pullrequest to the openocd project?

[TuanLam]

Hello Zhiming_Liu,

Can you please share the patch for openocd.

Regards,

[Z2025121]

Hello Zhiming_Liu,

Could you please send me the patch for openocd as well.

Many thanks,

JS

[torus1000]

Hi @Zhiming_Liu

Could you please send me @torus1000 that patch as well?

[vraevsky]

Hello Zhiming_Liu,

Can you please share the patch for openocd.

Regards,

VR.