Hi Everyone
Is there anyway to detect the voltage(High/Low) on the Boot_Mode0/1 pin after Login (Boot is successful)?
Boot_Mode0/1 does not seem to be able to set IOMUX as GPIO.
Thank you.
Haryanl
Solved! Go to Solution.
Hello,
No, please note that BOOT_MODE0/BOOT_MODE1 pin does not have a muxing option as you have seen in the schematic.
Best regards,
Aldo.
Hello,
No, please note that BOOT_MODE0/BOOT_MODE1 pin does not have a muxing option as you have seen in the schematic.
Best regards,
Aldo.