Unable to boot the QNX image in my imx8mp custom board

[Subash]

Hi,

I am using the IMX8MP custom board. The difference between the IMX8MP EVK and my custom board is the UART console and DRAM. After applying the changes to my QNX 7.1 source code, I tried to boot my board, but I couldn't see any console messages from my IMX8MP custom board. Are there any other changes that need to be made in the QNX 7.1 source code?


Thanks & Regards,
Subash.

[Bio_TICFSL]

Hello,

You need to check the console in you QNX source code, as well the RAM definition on its uboot and kernel bootargs.

Regards