USB OTG power group conflict

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

USB OTG power group conflict

696 Views
vinythambi
Contributor I

As per imx6 solox refrence design, E18 pin is used as USB OTG2 OC signal. When this function is configured in iomux tool, power group conflict warning pops up. Is this warning ignorable or function change is required?

pastedImage_2.png

Labels (1)
0 Kudos
Reply
1 Reply

622 Views
diegoadrian
NXP Employee
NXP Employee

Hello,

Could you please tell me the Pins Tool version that you are using? And what is the complete name that you are using to configure the Chip? I cannot see the same warning that you have by my side.

Best regards,

Diego.

0 Kudos
Reply