PF3000 : Stanby ( Suspend ) state transition time

koichisakagami · ‎08-17-2016

Dear community,
We have been developing our product with PF3000.

I have a question about Stanby ( Suspend ) state transition time.

The Standby mode is entered when a STANDBY pin is asserted.

[Question]
How long does it take to enter the Standby mode by asserting the STANDBY pin ?

Best Regards,
Koichi Sakagami

igorpadykov · ‎08-17-2016

Hi Koichi

according to sect.6.3.8.2 Dynamic voltage scaling PF3000 Datasheet :

2. Voltage transitions initiated by a Standby event are governed by the DVS stepping rates shown in Table 48.

Best regards

igor

-----------------------------------------------------------------------------------------------------------------------

Note: If this post answers your question, please click the Correct Answer button. Thank you!

-----------------------------------------------------------------------------------------------------------------------

igorpadykov · ‎08-17-2016

Hi Koichi

according to sect.6.3.8.2 Dynamic voltage scaling PF3000 Datasheet :

2. Voltage transitions initiated by a Standby event are governed by the DVS stepping rates shown in Table 48.

Best regards

igor

-----------------------------------------------------------------------------------------------------------------------

Note: If this post answers your question, please click the Correct Answer button. Thank you!

-----------------------------------------------------------------------------------------------------------------------