Hello. I am trying to make Compulab's debian distro be more adequate for my needs, and as there no way to use Yocto for cm-fx6, i try to make everything on my own.
The problem is, that i've installed vivante drivers, and they gave me libEGL, libGL, and etc., but there is no driver for X11, that should be in /usr/lib/xorg/modules/drivers/
Where do i find it? Here is my xorg.conf: [Xorg Config] Section "Module" Load "extmod - Pastebin.com
Solved! Go to Solution.
Hi Oleg
you can check below for available vivante drivers
L3.10.17_1.0.0_IMX6QDLS_BUNDLE : Source Code
If you will not find necessary drivers please post
this to meta-fsl-arm mailing list, so that someone familiar with this board
s/w distribution could try to assist you.
https://lists.yoctoproject.org/listinfo/meta-freescale
Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Hi Oleg
you can check below for available vivante drivers
L3.10.17_1.0.0_IMX6QDLS_BUNDLE : Source Code
If you will not find necessary drivers please post
this to meta-fsl-arm mailing list, so that someone familiar with this board
s/w distribution could try to assist you.
https://lists.yoctoproject.org/listinfo/meta-freescale
Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------