I.MX6Q is Unable boot

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

I.MX6Q is Unable boot

650 Views
lukegu
Contributor I

Hi Dear ,

 

       My customer uses the MfgTool burned the u-boot , the process is OK , and the printf is right . But It doesn't boot normally . Could you kindly help me to check this issue? Thanks a lot !

Original Attachment has been moved to: cfg.ini.zip

Original Attachment has been moved to: ucl2.xml.zip

Labels (1)
0 Kudos
1 Reply

384 Views
igorpadykov
NXP Employee
NXP Employee

Hi luke

for new board it is necessary to run ddr test

i.MX6/7 DDR Stress Test Tool V2.51

then rebuild uboot with new settings obtained from test,

modifying uboot *.cfg file. May be useful refer to attached

document Chapter 1 Porting U-Boot

Best regards

igor

-----------------------------------------------------------------------------------------------------------------------

Note: If this post answers your question, please click the Correct Answer button. Thank you!

-----------------------------------------------------------------------------------------------------------------------

0 Kudos