How to Enable Uart 1 in JN5168?

[dheerajsawant]

Hello Community, 

I want to use 2 uart (UART0 & UART1).

i am using AN-1229 Application Note, in this i can able to use UART0. 

But now i am trying to use UART1. 

How will i enable Both UARTs. 

Please explain if you know about this.

(*Note)- i am aware of HardWare part.i am using DIO9 as RXD1 and DIO11 as TXD1. 

Please reply as soon as possible.

Best Regards, 
Dheeraj Sawant

[dheerajsawant]

Hello All, 

Now its working! :smileyhappy:

i just used 3 steps and its done

1)must enable uart 1

2) set location of uart 1 pins in programming window

3) set baud rate.

and it will works!

Thanks You