need polling configuration of ICU in S32Ds for S32k344

[RushikeshK_DC]

I need to configure ICU for measuring duty cycle and  frequency of PWM signal using polling mode for S32k344 using design studio. If anyone has pls share with me.

[_Leo_]

Hi,

Thank you so much for your interest in our products and for using our community.

You could refer to the following community posts:

https://community.nxp.com/t5/S32K-Knowledge-Base/Example-IP-S32K312-PWM-ICU-using-EMIOS-DS3-5-RTD300...

https://community.nxp.com/t5/S32K-Knowledge-Base/Example-S32K344-eMIOS-DS3-5-RTD500/ta-p/1992245

Hope it helps you.

Have a nice day!

[RushikeshK_DC]

I have tried the polling mode by enabling the checkbox of IcuSignalMeasurementWithoutInterrupt In using MBDT in Simulink but even it not working.

[_Leo_]

For questions related to MBDT we have a specific forum, where experts on the subject can help you. I am going to ask you please to direct the related questions in the following community:

Model-Based Design Toolbox (MBDT)

I appreciate your understanding.