12-02-2022
01:41 AM
731 Views
jingfang
Contributor IV
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can't find the instructions for "Continuous Measurement".
How do I use "Continuous Measurement"?
Solved! Go to Solution.
1 Solution
12-02-2022
04:35 AM
723 Views
danielmartynek
NXP TechSupport
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @jingfang,
In the S32K1xx RM rev.14, refer to Section 47.5.26.3 Pulse width measurement.
There are two modes:
In the continuous mode, to start a new mesurement, we just have to clear the (n) (n+1) CHF flags, and this is done by the driver in this case.
Regards,
Daniel
1 Reply
12-02-2022
04:35 AM
724 Views
danielmartynek
NXP TechSupport
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @jingfang,
In the S32K1xx RM rev.14, refer to Section 47.5.26.3 Pulse width measurement.
There are two modes:
In the continuous mode, to start a new mesurement, we just have to clear the (n) (n+1) CHF flags, and this is done by the driver in this case.
Regards,
Daniel