When I using j-link debug s32k144,it is empty in peripheral registers values and peripheral register windows.It is ok in using usb link.
Solved! Go to Solution.
Hi 郑文豪,
If you are using S32DS IDE, please try to use the EmbSys Registers window.
Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!
- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------
Hi 郑文豪,
If you are using S32DS IDE, please try to use the EmbSys Registers window.
Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!
- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------
There is no value.
Double click on register to read values, after that the register names will shown green.
Thank you !