Can not find brown-out detection operating requirements

[PYGC]

The module operation in available power modes for brown-out detection is described in the reference manual, but the corresponding operating requirements can not be found in the data sheet.

[Robin_Shen]

Hi PYGC,

Please read the chapter "5 S32K1xx brownout detection" of AN11983. Let me know what kind of data you need.

Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------

[PYGC]

What is the difference between this(EEE) and POR's brownout detect

[Robin_Shen · Accepted solution]

Hi PYGC,

Sorry for the confusion caused to you by the ambiguity of the contents of the manual.

It should be POR(Brown-out Detection) in Table 39-4.

So please check the VPOR in S32K-DS.pdf

Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------