Design files of MagniV demo board

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Design files of MagniV demo board

Jump to solution
1,850 Views
Georgio_69
Contributor II

Hello,

We are trying to design a new shield for the MagniV evaluation board. Is it possible to have all the electronic files (Schematic, BOM, gerber files) for the board S12ZVM12EVB (pdf file S12ZVMC12EVBCAN_SCH)?

It will be very helpful for several reasons especially to have the connectors at the same place. 

Thanks a lot

Kind regards,

Georges FRAPPA

0 Kudos
1 Solution
1,825 Views
StanoA
NXP TechSupport
NXP TechSupport

The files belongs to OrCAD.

Have fun!

Stano.

View solution in original post

6 Replies
1,846 Views
Georgio_69
Contributor II

Additional comments : my intention was to get Gerber files and schematic files from CAD tool (if possible of course). I can not use pdf files directly.

 Thanks in advance for your feed-back

 Best regards,

0 Kudos
1,839 Views
StanoA
NXP TechSupport
NXP TechSupport

Hello Georgio,

I have sent you the file Board.zip which contains all you need – also the requested data. Just unpack it and open GRB….zip file.

Best Regards,

Stano.

0 Kudos
1,836 Views
Georgio_69
Contributor II
Hello, Thanks for the reply but I didn't receive any file in my mail box? Can you check please? Thanks again. Best regards
0 Kudos
1,832 Views
StanoA
NXP TechSupport
NXP TechSupport

Hello Georgio,

OK, please see attached file. May be it was such mistake.... sorry.

Best Regards,

Stano.

 

0 Kudos
1,829 Views
Georgio_69
Contributor II
Well received : thanks a lot !! Last question (sorry) : what is the CAD Software used? Eagle? Orcad? Altium?... Thanks in advance Best regards
0 Kudos
1,826 Views
StanoA
NXP TechSupport
NXP TechSupport

The files belongs to OrCAD.

Have fun!

Stano.