FPGA access using P5040 processor via eLBC

キャンセル
次の結果を表示 
表示  限定  | 次の代わりに検索 
もしかして: 

FPGA access using P5040 processor via eLBC

ソリューションへジャンプ
1,557件の閲覧回数
hemwant
Contributor IV

We are having a customised P5040 board with FPGA device[8bit access] configured at CS2 of eLBC . We are not able to access the registers of FPGA from uboot . On further debugging the issue with oscilloscope, the CS2 is not being asserted when we initiate read/write from uboot. 

The dump of complete uboot, eLBC and LAW registers is attached with this post.

タグ(2)
0 件の賞賛
1 解決策
1,297件の閲覧回数
hemwant
Contributor IV

@yipingwangthis issue is resolved , FPGA was configured for little endian whereas processor is accessing in big endian mode.

元の投稿で解決策を見る

0 件の賞賛
2 返答(返信)
1,301件の閲覧回数
yipingwang
NXP TechSupport
NXP TechSupport

Can you please share your schematic?

0 件の賞賛
1,298件の閲覧回数
hemwant
Contributor IV

@yipingwangthis issue is resolved , FPGA was configured for little endian whereas processor is accessing in big endian mode.

0 件の賞賛