SBC FS6513CAE

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

SBC FS6513CAE

Jump to solution
787 Views
qiaoqin_wang
Contributor III

i have a confusion about the SBC 6513CAE,while the FS0B and FS1B output is the same as the SBC error output during the SBC start up?

0 Kudos
1 Solution
778 Views
qiaoqin_wang
Contributor III

i have confused about the as the below content show:

Second output of the safety block (active low). The pin is asserted low at
start-up and when a fault condition is detected, with a configurable delay or
duration versus FS0B output terminal. Open drain structure

while the FS0B status is the same as the fault condition action when at start up,

and the start up means the SBC from sleep mode to wake up mode?

could you help me to understand ,thanks.

View solution in original post

0 Kudos
3 Replies
769 Views
guoweisun
NXP TechSupport
NXP TechSupport

You can see the datasheet page 39 Figure 16. Simplified state diagram revison7.

The right part of statup  flow chart can explain your concern.

0 Kudos
781 Views
guoweisun
NXP TechSupport
NXP TechSupport

what's your question? please descript it detailly.

 

 

0 Kudos
779 Views
qiaoqin_wang
Contributor III

i have confused about the as the below content show:

Second output of the safety block (active low). The pin is asserted low at
start-up and when a fault condition is detected, with a configurable delay or
duration versus FS0B output terminal. Open drain structure

while the FS0B status is the same as the fault condition action when at start up,

and the start up means the SBC from sleep mode to wake up mode?

could you help me to understand ,thanks.

0 Kudos