PEMicro configuration for MPC5748G

cancel
Showing results for 
Search instead for 
Did you mean: 

PEMicro configuration for MPC5748G

373 Views
tobiasmrowietz
Contributor I

We are using the PEMicro Multilink FX for flashing and debugging our MPC5748G and encountered few issues so far.

Could you maybe help us with setting up a correct configuration here?

  • The debugger takes a lot of time to step over instructions to the point where the program is suspended with no message in console.
  • It takes a lot of time to flash the MCU at random iterations (gets stuck at 97% for a few minutes).
  • When going over some instructions the session is terminated with the following message in console :

Remote communication error.  Target disconnected.: No error.

Quit (expect signal SIGINT when the program is resumed)”.pastedImage_1.png

0 Kudos
1 Reply

265 Views
martin_kovar
NXP Employee
NXP Employee

Hello,

could you please tell me, which version of S32DS you use?

I recommend to use S32DS 2017.R1 with update 10, please see the link below.

https://community.nxp.com/docs/DOC-343018 

The settings you shared looks correct. Do you use your own design board or NXP evaluation board?

Please let me know.

Regards,

Martin

0 Kudos