PTN5110 VBUS get PDO message but then getting hard reset issue

[jignesh1]

Hi All, 

We have board where we use PTN5110 chip to get Power with TypeC. Product needed 20V.

So I have one mcu connected to it and have i2c communication with PTN5110.

In current development we are able to get PDO but after getting PDO I observed that getting hard reset stage from alert interrupt. So please guide me if I missing any thing regarding this.

If we have any sequence of register or MCU example available to get higher voltage please share here.

Attaching i2c analyzer log that we have captured that can give some hint about issue. 

[AldoG]

Hello,

On the file that you have shared I see that you are using an i.MX8 is this correct?
How are you testing PTN5110 is it through Linux?

Best regards/Saludos,
Aldo.