How to set Canbus Standby Pin

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

How to set Canbus Standby Pin

637 Views
justsomeonelse
Contributor I

Hello,

 

I am trying to configure the TJA1044 STB pin to HIGH to enter standby mode. But, I cannot figure out how to configure this pin.

 

Schema of TJA1044 and LPC55s06 connection given below. How can I set to HIGH instead of LOW to STB pin of TJA1044?

tja1044_lpc5506.png

Labels (1)
0 Kudos
2 Replies

616 Views
Alice_Yang
NXP TechSupport
NXP TechSupport

Hello justsomeonelse,

You can do some overwork with this board, connect STB to a gpio of lpc55s06 to control. 

 

BR

Alice

0 Kudos

629 Views
carstengroen
Senior Contributor II

By connecting the "top" of R29 (the wire to STB on the CAN transceiver) to +3.3V ?
There is no GPIO connected to that if thats what you are asking, according to the schematics..

0 Kudos