Hello,
I am using processor expert with keil. The problem is that my program runs in debug only. It's not running at por. As I read in the other threads, there is no "librarian" settings found in PE. I am running from internal oscillator. 32khz oscillator is connected but not configured to use. Another problem is that I have to flash the program before debugging(= flashing two times, one when starting debugging and another before that).
Using my own board, opensda that comes with fdrm-ke02z. Fdrm processor is disconnected removing jumper resistor
. Kindly help. Thank you.
已解决! 转到解答。
Hi Suraj,
I think the root cause is relate to the hardware circuit and you can go for a test again by following the steps below.
1. Just remain the mini-system after remove the stuffs on your own board;
2. Debug and program the KExx_DRV_lib projects to mini-system;
3. Check out the run result of the after programming and POR;
Hope it helps.
Have a great day,
Ping
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Hello Jeremy,
Now the PE project has started to running after flashing, but not after por. The kexx_DRV_lib projects still fail to start on por/after flashing. I think the reset circuitry is clean, I have .1uF cap at the reset pin. Voltage at the reset pin is stable.
Thank you.
Hi Suraj,
I think the root cause is relate to the hardware circuit and you can go for a test again by following the steps below.
1. Just remain the mini-system after remove the stuffs on your own board;
2. Debug and program the KExx_DRV_lib projects to mini-system;
3. Check out the run result of the after programming and POR;
Hope it helps.
Have a great day,
Ping
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Hi Suraj,
Before answer your question, I'd like to get the more information about the question.
Did the FRDM-KEXX Driver Library package run well on your own board or not?
Did the demo code work well on the FRDM-KE02 board or not?
FRDM-KEXX Driver Library package:https://www.nxp.com/webapp/sps/download/preDownload.jsp
Have a great day,
Ping
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
The kexx_DRV projects as such do not run on my board unless I am debugging(very slow since I have 32khz crystal). They ran well on the freedom board. Similar is the project created by PE. Is my hardware the problem? But it's running smooth in debugging.