Dear Folks,
The reset pin is connected to internal pull up according to the that datasheet.
The reset pin on my PCB measures 1.5 Volts, but I am expecting 3.3v due to which i can not Flash my microcontroller.
The reset pin measures 1.5v when connected with a 3k resistor and 2.5v when connected with 1k resistor (Please find the resistor circuit in the attachment).
I can Flash my microcontroller when the reset pin measures 2.5v.
Questions
1) Why does the reset pin measure 1.5v when we have 3k resistor.
Best regards,
Suresh Jaggal
Hi Suresh
I am not sure whether you have observe the waveform on reset pin by using oscilloscope.
If the waveform seems periodic oscillation, you may check the RESET_b pin and the NMI_b pin.
You can check the circuits according to the "2.1.3.4.1 RESET_b and NMI_b" of KLQRUG.pdf
Best Regard
Robin