Can not program kv58f1m0vlq24 on custom board

[kutay]

Hi everyone,

I try to program kv58f1m0vlq24 mcu on custom designed board with JTAG interface via pemicro u-multilink. When i click to debug button, debug session starts but terminates immediately after. So, i can not observe any problem or error on debug console. But when i try to program with "GUI Flash Tool" on mcuxpresso ide, i get errors. (errors on screenshot) Is there anyone can help?

[Celeste_Liu · Accepted solution]

Hello @kutay ,

Thank you for your interest in NXP Semiconductor products and for the opportunity to serve you.

I'd like to know does a similar error still happen when you try other debug tools?

Please attached the circuit of MCU(how did you connect it with MCU)?

You can also refer to the following post: How To Sucessfully Program a Custom made Kinetis Microcontroller Board. - NXP Community

Have a great day,

Celeste

--------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
--------------------------------------------------------------------------------------------------------

[kutay]

Hi,

Thanks for answer and sorry for replying too late. My debugger pe-micro multilink is too old (estimately produced at 2015). So, i changed "Debug Shift Freq" in Target Communication Speed at debug configuration pane as 100 kHz. After made this change, i am be able to debug custom board.

Thank you for your time.

[Celeste_Liu]

Hello @kutay ,

I'm glad to hear that. Any new issues, welcome to create a new post.

BRs,

Celeste