Currently in Code Warrior (5.9.0), I select "Debug" in order to flash a new version of code. How can I use the debugger against code that it has already flashed if I wish to do another debug session a day or two later. Right now it is reflashing each time I select debug.
I am using an MCS12XD
Hello Jay,
There is not the selection for this .
- While if you only want to debug , i think you can use the "Full chip simulation" to debug.
- And also you can configure the .prm file , place all of the code into RAM when your
code is small , (in this method, if the size code larger , the RAM not enough ).
Hope it helps
Alice
Hi Jay,
Could you tell us which MCU are you using?
Thanks in advance!
Best Regards,
Carlos Mendoza
Technical Support Engineer