How to configure PT0, PT1 for SCI(RXD1, TXD1) in S12ZVCA 48 pins?

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

How to configure PT0, PT1 for SCI(RXD1, TXD1) in S12ZVCA 48 pins?

Jump to solution
899 Views
aaronlee
Contributor V

Hi,

I am using S12ZVCA 48 pins. How to configure PT0, PT1 for SCI(RXD1, TXD1) in Processor Expert?

pastedImage_1.png

P.S. I could only find SCI0(PS0, PS1) in MC9S12ZVCA192MLF.

Best Regard,

Aaron

Tags (3)
1 Solution
626 Views
ZhangJennie
NXP TechSupport
NXP TechSupport

Hi Aaron,

I use CW11.

pastedImage_1.png

Your issue should be CW10.6 defect. and it has been fixed in latest CW11.


Have a great day,
Jennie Zhang

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

View solution in original post

6 Replies
626 Views
ZhangJennie
NXP TechSupport
NXP TechSupport

hi.

Did you select the right channel in "Properties", please refer below to set yours.

pastedImage_2.png

Can this help you?


Have a great day,
Jennie Zhang

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

0 Kudos
626 Views
aaronlee
Contributor V

Hi,

I try to use configuration of 64 pins S12ZVCA. It can choice channel 1 now.

But my real MCU is 48 Pins. May i using 64 Pins configuration for 48 Pins MCU? or any recommand?

pastedImage_1.png

Best Regards,

Aaron

0 Kudos
626 Views
ZhangJennie
NXP TechSupport
NXP TechSupport

Hi Aaron,

You need go to "Processors" to select right processor pin variant for your chip.

pastedImage_1.png

For detail, see attached video.


Have a great day,
Jennie Zhang

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

0 Kudos
626 Views
aaronlee
Contributor V

Hi Jennie,

I following your video, but still no SCI1. (Please see attached video)

What version of Processor Expert are you using? How to upgrade?

pastedImage_1.png

0 Kudos
627 Views
ZhangJennie
NXP TechSupport
NXP TechSupport

Hi Aaron,

I use CW11.

pastedImage_1.png

Your issue should be CW10.6 defect. and it has been fixed in latest CW11.


Have a great day,
Jennie Zhang

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

626 Views
aaronlee
Contributor V

Hi Jennie,

Why does my SCI only channel 0? How to add channel 1?

pastedImage_1.png

Best Regards,

Aaron

0 Kudos