How to map values of Output Power in Connectivity Test Application

vishnubeema — Mon, 15 Jan 2018 03:41:30 GMT

Hello,

In SMAC “Kinetis SMAC Demo Applications User's Guide.pdf” under “Chapter 4 Kinetis Connectivity Test Application” there is an option to change the output power value. But its mentioned to see corresponding reference manual. From where I can find this mapping between the register value and the converted dBm value.

‘s’ : decrements output power value. If output power is at minimum and this key is pressed, the output power will go to maximum (in this case 0x1C). These are not directly mapped to dBm values. Instead the output power value is written to the appropriate register. The user should consult the reference manual to determine the relationship between selected value and power in dBm.

Thanks & Regards

Vishnu Beema

Re: How to map values of Output Power in Connectivity Test Application

stephanie_m — Tue, 16 Jan 2018 22:28:09 GMT

Hello,

Additionally, you can check the Data Sheet on page 27 for further information.

Best Regards,

Estephania

Wireless MCUのトピックRe: How to map values of Output Power in Connectivity Test Application

How to map values of Output Power in Connectivity Test Application

Re: How to map values of Output Power in Connectivity Test Application