topic Re: Thread Example Not working in Wireless MCU

Thread Example Not working

pierslfx — Wed, 13 Sep 2017 07:59:56 GMT

Hello,

I am trying to get the thread host interface example working.

I have downloaded the SDK from Welcome to MCUXpresso | MCUXpresso Config Tools and I am trying to run the frdmkw41z_wireless_examples_thread_host_controlled_device_freertos example.

I have flashed it to my frdmkw41z board, which flashes the RGB LED blue. I connected a UART to USB adapter running on COM 4.

I downloaded the NXP Test Tool 12 to test out the THCI functionality. It recognizes the com port. Whenever I send a command, there is a TX entry but no RX response. If I plug the board in when its off, I can see a few RX commands as the board starts up.

Any help would be greatly appreciated.

Re: Thread Example Not working

stephanie_m — Wed, 13 Sep 2017 22:24:19 GMT

Hello,

To try to recreate your issue, could you please tell me which IDE are you using?

Best Regards,

Estephania

Re: Thread Example Not working

pierslfx — Thu, 14 Sep 2017 02:40:37 GMT

Hello,

I am using the MCUXpresso IDE v10.0.2 [Build 411] [2017-07-11] .

Thank you in advance!

Piers

Re: Thread Example Not working

stephanie_m — Thu, 21 Sep 2017 00:51:27 GMT

Hello,

I used the latest version available in the MCUXpresso web page, and I did not have any problem while working with the Test Tool.

Which baud rate are you using?

Best Regards,

Estephania