topic Re: JN5179:Load Binary File into Flash Memory in Wireless MCU

JN5179:Load Binary File into Flash Memory

wupengfei — Tue, 12 Sep 2017 13:11:35 GMT

$ JN51xxProgrammer.exe -s COM3 -f AN1211_154_EndD_JN5179.bin

----- Error:reading chip ID-check cabling and power

Failed to read chip details on COM3

Re: JN5179:Load Binary File into Flash Memory

mario_castaneda — Wed, 13 Sep 2017 21:42:54 GMT

Hi Pengflei,

Could you please check the in the device manager that the JN5179 driver is installed correctly?

Also, if this a custom board make sure you connect the RX of programmer to TX of module and vice versa
VDD, GND, SPIMISO to Ground, RESET to Ground then 3.3v.

Please let me know your findings.

Best Regards,

Mario

Re: JN5179:Load Binary File into Flash Memory

davidashraf — Thu, 14 Sep 2017 04:09:52 GMT

Hello wupengfei‌
You may want to have a look here
https://community.nxp.com/thread/460072

Regards

Re: JN5179:Load Binary File into Flash Memory

wupengfei — Thu, 14 Sep 2017 07:09:40 GMT

thinks for your help ,I am following your instructions to achieve it。

Re: JN5179:Load Binary File into Flash Memory

davidashraf — Thu, 14 Sep 2017 07:30:34 GMT

wupengfei‌
You are welcome
Please If it worked with you mark it as correct and helpful for others searching on the same problem find the solution easily
If not , comment with any other solution you found to edit and modify the document.

Thanks and Regards