https://community.nxp.com/t5/Wireless-MCU/ZigbeeNodeControlBridge-IN-JN5169/m-p/1765876#M16066 <P>Hello,</P> <P>&nbsp;</P> <P>Hope you are doing well.</P> <P>Could you please confirm how are you loading your application?</P> <P>&nbsp;</P> <P>If you are using BeyondStudio, please refer to section 3.3 Loading an Application into a Device of the <A href="https://www.nxp.com/docs/en/user-guide/JN-UG-3098.pdf" target="_blank">BeyondStudio for NXP Installation and User Guide</A>, there you can see on Step 4 the options for the EEPROM.</P> <P>Hope this helps!</P> <P>&nbsp;</P> <P>Regards,</P> <P>Ricardo</P> Wed, 29 Nov 2023 17:58:30 GMT Ricardo_Zamora 2023-11-29T17:58:30Z https://community.nxp.com/t5/Wireless-MCU/ZigbeeNodeControlBridge-IN-JN5169/m-p/1764441#M16040 <P><SPAN>When the gateway has burned down the ZigbeeNodeControlBridge firmware and added several router devices, and then re burned the ZigbeeNodeControlBridge, how to maintain all router information of the coordinator, including shortaddress, without the need to reconfigure the network</SPAN></P> Tue, 28 Nov 2023 02:31:05 GMT https://community.nxp.com/t5/Wireless-MCU/ZigbeeNodeControlBridge-IN-JN5169/m-p/1764441#M16040 Janson 2023-11-28T02:31:05Z https://community.nxp.com/t5/Wireless-MCU/ZigbeeNodeControlBridge-IN-JN5169/m-p/1765876#M16066 <P>Hello,</P> <P>&nbsp;</P> <P>Hope you are doing well.</P> <P>Could you please confirm how are you loading your application?</P> <P>&nbsp;</P> <P>If you are using BeyondStudio, please refer to section 3.3 Loading an Application into a Device of the <A href="https://www.nxp.com/docs/en/user-guide/JN-UG-3098.pdf" target="_blank">BeyondStudio for NXP Installation and User Guide</A>, there you can see on Step 4 the options for the EEPROM.</P> <P>Hope this helps!</P> <P>&nbsp;</P> <P>Regards,</P> <P>Ricardo</P> Wed, 29 Nov 2023 17:58:30 GMT https://community.nxp.com/t5/Wireless-MCU/ZigbeeNodeControlBridge-IN-JN5169/m-p/1765876#M16066 Ricardo_Zamora 2023-11-29T17:58:30Z