SensorsのトピックRe: Using Arduino interface of MIMX RT1170 EVK for sensor connection

Using Arduino interface of MIMX RT1170 EVK for sensor connection

SK02 — Thu, 11 Jun 2026 07:09:30 GMT

Hello.

I am interfacing ultrasonic sensor to MIMX RT1170 EVK board. For interfacing the sensor I need to use Arduino interface for GPIOs connection. I am not able to find the proper connections for ultrasonic sensor connection, because not getting power at the pins.

I gave supply to board using adapter (J43).
I need reference for pins connection and are there any settings required for powering ON the arduino interface region?

Thank you.

Re: Using Arduino interface of MIMX RT1170 EVK for sensor connection

mayliu1 — Fri, 12 Jun 2026 02:36:56 GMT

Hi @SK02 ,

Thank you so much for your interest in our products and for using our community.

regarding your issue, could you please verify the following power configuration?

1: The adapter is connected to J43

2: The SW5 power switch is turned ON

3: J38 is set to pins 1–2 to select the external 5 V input

Once these settings are confirmed, the board power rails—including those supplying the Arduino interface—should be available.

Please try it.

Best Regards

May