topic Re: i2c giving NACK in S32 SDK

i2c giving NACK

MohitManvar — Mon, 31 Jul 2023 06:29:26 GMT

Hello,

I am using S32 design studio and S32K142-100pin Eval board.

I am trying to connect board with TI's TAS5720 with i2c configuration example using peripheral option in IDE.

it is giving NACK although I am giving proper address of slave and having pin connection as per standard.

This configuration is working with other i2c device and I checked with HW there is no problem from HW. so can anyone have idea or share some details on this.

Thanks!!

Re: i2c giving NACK

danielmartynek — Mon, 31 Jul 2023 10:42:29 GMT

Hi @MohitManvar,

Have you measured the bus with an oscilloscope?

Can you share the oscillograms?

If there is no problem with the signal from the S32K MCU, please contact TI support.

Regards,

Daniel

Re: i2c giving NACK

MohitManvar — Mon, 31 Jul 2023 11:04:36 GMT

hello,

Find this helpful to you

Re: i2c giving NACK

danielmartynek — Mon, 31 Jul 2023 12:09:09 GMT

0x48 is not an address of the chip:

https://www.ti.com/lit/ds/symlink/tas5720l.pdf?ts=1690775518844&ref_url=https%253A%252F%252Fwww.ti.com%252Fproduct%252FTAS5720L%253Futm_source%253Dgoogle%2526utm_medium%253Dcpc%2526utm_campaign%253Dasc-null-null-44700045336317125_prodfolderdynamic-cpc-pf-google-wwe_int%2526utm_content%253Dprodfolddynamic%2526ds_k%253DDYNAMIC%2BSEARCH%2BADS%2526DCM%253Dyes%2526gclid%253DEAIaIQobChMIm9K7t4W4gAMVDz6RCh1YGQdiEAAYASAAEgKyd_D_BwE%2526gclsrc%253Daw.ds

BR, Daniel

Re: i2c giving NACK

MohitManvar — Mon, 31 Jul 2023 12:40:59 GMT

Hello,

i used 0x6C as address this is only snap of I have from other slave device.

Please consider 6c as address and provide solution

Thanks!!

Re: i2c giving NACK

danielmartynek — Tue, 01 Aug 2023 07:14:46 GMT

Hello @MohitManvar,

Does it mean the waveform you posted shows a completely different communication?

It is hard to say what is wrong if you do not measure the signals.

The satasheet of the slave device specifies the required I2C format and timimng.

Regards,

Daniel

Re: i2c giving NACK

MohitManvar — Tue, 01 Aug 2023 07:30:39 GMT

Hello @danielmartynek

please find below snap for your reference

slave address : 0x6C

slave speed: 100kbps

blue:SCL , Red:SDA

Br,
Mohit

Re: i2c giving NACK

danielmartynek — Tue, 01 Aug 2023 08:32:21 GMT

The address is correct assuming correct HW configuration.

7 MSB 0x6C

0xD8 for a write.

Why is the volatage of the SDA signal higher that SCL?

The datasheet of the slave device specifies the I2C.

Can you double-check the timing?

BR, Daniel