https://community.nxp.com/t5/S32-SDK/quot-PinSettings-quot-component-settings-in-Processor-Expert-PE/m-p/743067#M317 <HTML><HEAD></HEAD><BODY><P>Hello, </P><P></P><P>please check the thread below:</P><P><A href="https://community.nxp.com/message/936264">https://community.nxp.com/message/936264</A>&nbsp;</P><P></P><P>Regards,</P><P>Martin</P></BODY></HTML> Fri, 03 Nov 2017 12:21:22 GMT martin_kovar 2017-11-03T12:21:22Z https://community.nxp.com/t5/S32-SDK/quot-PinSettings-quot-component-settings-in-Processor-Expert-PE/m-p/743066#M316 <HTML><HEAD></HEAD><BODY><P>Hi,</P><P></P><P>In most of the S32 SDK &nbsp;Demo &nbsp;projects ( for example lptmr_periodic_interrupt_s32k144 and power_mode_switch_s32k144)&nbsp; all unused Pins&nbsp;have their&nbsp; "Pin Mux" set to "Pin disabled (analog)".&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; Is this&nbsp;the recommended setting for all unused Pins in a real application as well?&nbsp;&nbsp;&nbsp; If not, could you&nbsp;please suggest the recommended settings for unused pins in the &nbsp;"Pin Settings" component in order to achieve lowest possible&nbsp;&nbsp;power consumption both in RUN and STOP modes.</P></BODY></HTML> Thu, 02 Nov 2017 18:55:58 GMT https://community.nxp.com/t5/S32-SDK/quot-PinSettings-quot-component-settings-in-Processor-Expert-PE/m-p/743066#M316 sreenivasuluvak 2017-11-02T18:55:58Z https://community.nxp.com/t5/S32-SDK/quot-PinSettings-quot-component-settings-in-Processor-Expert-PE/m-p/743067#M317 <HTML><HEAD></HEAD><BODY><P>Hello, </P><P></P><P>please check the thread below:</P><P><A href="https://community.nxp.com/message/936264">https://community.nxp.com/message/936264</A>&nbsp;</P><P></P><P>Regards,</P><P>Martin</P></BODY></HTML> Fri, 03 Nov 2017 12:21:22 GMT https://community.nxp.com/t5/S32-SDK/quot-PinSettings-quot-component-settings-in-Processor-Expert-PE/m-p/743067#M317 martin_kovar 2017-11-03T12:21:22Z