S32 Design Studio中的主题 Re: How to ConfigurationPE micro JTAG?

How to ConfigurationPE micro JTAG?

kbj8941 — Thu, 12 Mar 2020 00:21:33 GMT

Hi Reader,

I have a S21K144EVB and a PE micro Multilink universal.

I just want set up JTAG Debug without openSDA.

I want to know configuration at S32 Design Studio for ARM Version 2018.R1.

I attach the setting image.

Re: How to ConfigurationPE micro JTAG?

jiri_kral — Thu, 12 Mar 2020 07:14:38 GMT

Hi,

it looks that you have swapped out JTAG cable. PIN #1 is on the Right side, not on the left as your image shows.

Jiri

Re: How to ConfigurationPE micro JTAG?

kbj8941 — Thu, 12 Mar 2020 08:21:37 GMT

Hi, Jiri

Thanks for reply.

I have some question,

when don't it have openSDA schematic, how can i debbuger configuration using the multilink unviersal Fx with S32 studio?

Re: How to ConfigurationPE micro JTAG?

jiri_kral — Thu, 12 Mar 2020 09:01:32 GMT

Hi,

Just choose Multilink FX probe in Debug configurations and connect JTAG cable. Make sure, that you have power for MCU (external 12V power supply or USB) - for USB J107 - shorted 2-3, for external power supply J107 - shorted 1-2 .

Jiri

Re: How to ConfigurationPE micro JTAG?

kbj8941 — Fri, 13 Mar 2020 01:38:54 GMT

Hi, Jiri

Thanks for reply.

i did it this problem!

but i have another prlblem. i need a your help.

I made a board for my project.

I designed like that attach the image.

I connected Pin170(reset) and Pull up with the switch.

but voltage muresed always low signal(about 0.1V) at reset pin. so i think i can't debug using the JTAG.

can you plz check this port and my schematic.

- Jin

Re: How to ConfigurationPE micro JTAG?

kbj8941 — Fri, 13 Mar 2020 01:57:33 GMT

i missed attach the image.