topic About the demo of FlexCan existed in S32 Design Studio 2018.R1 in S32 Design Studio

About the demo of FlexCan existed in S32 Design Studio 2018.R1

frank_feng — Thu, 24 Jan 2019 02:07:29 GMT

Recently , I start to use the demo flexcan_s32v234 existed in S32 Design Studio 2018.R1 , the demo is show below .

However when I debug this demo , I found the receive function works fine ,but the send function seems not working , I wonder before testing the send function of this demo if there is any configurations I need to change .According to my test, there is no output signal from pin A10 ,and if the demo works fine , there should be some output signal to be detected.Any information about this is needed , hope someone could give me some advice . I'll be very thankful

the tool I used to get and send the frame message

the pin I used for my device is A10 and B10

the send function which is not working normal is show below

the demo I used is show below

Re: About the demo of FlexCan existed in S32 Design Studio 2018.R1

frank_feng — Thu, 24 Jan 2019 06:56:53 GMT

it turns out the configuration of the dataInfo is not rightly set,after I change the setting of the dadaInfo as below shows ,sending function became normal

Re: About the demo of FlexCan existed in S32 Design Studio 2018.R1

stanish — Thu, 24 Jan 2019 11:29:02 GMT

Hi Cunjin,

Thanks for sharing the solution on community.

Stan