S32 Design StudioのトピックRe: Failure for debugging hello+pll

Failure for debugging hello+pll

hrfbit — Tue, 20 Mar 2018 13:46:06 GMT

what's wrong?

Re: Failure for debugging hello+pll

jiri_kral — Wed, 21 Mar 2018 06:44:32 GMT

Hi,

Are you using S32DS for Power or ARM? Is your debugger OpenSDA or other?

Jiri

Re: Failure for debugging hello+pll

stanish — Thu, 22 Mar 2018 14:57:15 GMT

Hi,

I assume you are using S32DS Power and MPC5748G DevKit Board with OpenSDA interface.

I'd recommend you to install the latest S32DS Power + Update 1:

S32 Design Studio for Power Architecture 2017.R1 (Windows/Linux) released!

S32 Design Studio for Power Architecture 2017.R1 - Update 1 available

Then please check if the OpenSDA firmware is up-to-date (v1.10). If not please update it:

HOWTO: Update OpenSDA Firmware on EVB

Finally check if the board and MCU is powered up - 5V_OK and 3V3_OK LEDs are ON.

Hope it helps.

Stan

Re: Failure for debugging hello+pll

hrfbit — Fri, 23 Mar 2018 14:34:37 GMT

OpenSDA

Re: Failure for debugging hello+pll

hrfbit — Mon, 09 Apr 2018 08:17:05 GMT

Google 翻译

Re: Failure for debugging hello+pll

stanish — Mon, 09 Apr 2018 15:21:59 GMT

Hi,

thanks for the update.

Could you create a new non-sdk project using project wizard build it and debug?

If it does not work there could be a hw issue - please check if the board is powered correctly (LEDs 5V_OK and 3V3_OK are on). If they are off please switch J1 jumper to 2-3 position.

Do you have an external debug probe to test e.g. P&E Multilink?

Stan