topic failed when debugging ethernet_UDP example project in S32 Design Studio in S32 Design Studio

failed when debugging ethernet_UDP example project in S32 Design Studio

yachuanliu — Sat, 24 Feb 2018 09:23:31 GMT

Hello all, a problem occurred when I debug the enet_rmii_udp project in MPC5748G from the S32 Design Studio example. I can’t debug the project successfully. The pictures below are the errors showed in S32 console tab when debugging this project.

Here are some other message you may need.

S32 version: S32 Design Studio for Power Architecture v1.2.
The enet_rmii_udp project: imported from S32DS Example Projects. And I didn’t change anything.
I debugged the hello example project successfully using the same computer, same MPC5748G.

I really need your help. Thanks.

Re: failed when debugging ethernet_UDP example project in S32 Design Studio

martin_kovar — Mon, 26 Feb 2018 08:36:16 GMT

Hello,

I tried to reproduce your use case, but unfortunately, I was not successful.

Do you use debug probe or you debug the example using USB and OpenSDA? Could you please send me you debug settings?

Regards,

Martin

Re: failed when debugging ethernet_UDP example project in S32 Design Studio

yachuanliu — Mon, 26 Feb 2018 13:10:44 GMT

Thank you very much for your help. Here are my debug configurations.

Regards,

Yachuan

Re: failed when debugging ethernet_UDP example project in S32 Design Studio

martin_kovar — Tue, 27 Feb 2018 13:45:13 GMT

Hello Yachuan,

which debug probe you use? Also, what is the board you use? Do you have Devkit or MPC5748G Evaluation Board?

Regards,

Martin

Re: failed when debugging ethernet_UDP example project in S32 Design Studio

yachuanliu — Wed, 28 Feb 2018 12:37:56 GMT

These are my debug probe and my board. Thank you again for your patience.

Re: failed when debugging ethernet_UDP example project in S32 Design Studio

martin_kovar — Wed, 28 Feb 2018 12:59:20 GMT

Hello,

thanks for information. Unfortunately, I do not have this debug probe to try it on my side.

Did you try to load all three projects using LaunchGroup or only the one for z4a core?

Could you please try to add 250ms delay after reset?

Regards,

Martin