S32 Design StudioのトピックRe: error after update to Arm v1.3 - Update 2

error after update to Arm v1.3 - Update 2

adrianwenger — Wed, 03 May 2017 15:29:09 GMT

HI,

after update i can not debug any more....

Regards,

Adrian

Re: error after update to Arm v1.3 - Update 2

martin_kovar — Thu, 04 May 2017 09:30:22 GMT

Hello,

could you please write me, which microcontroller you use?

Regards,

Martin

Re: error after update to Arm v1.3 - Update 2

adrianwenger — Thu, 04 May 2017 09:53:58 GMT

Hi,

yes, i use the S32K144EVB

regards

Re: error after update to Arm v1.3 - Update 2

jiri_kral — Fri, 05 May 2017 12:34:31 GMT

Hi Adrian,

I can't reproduce your issue - but I see that you have different PE micro debug plugin version. After last update - I have on my machine installed com.pemicro.debug.gdbjtag.pne plugin ver. 2.9.6, your vesion is 2.7.0.

As a quick fix without any investigation - just update PE micro plugin

https://community.nxp.com/thread/447395?commentID=890477#comment-890477

Jiri

Re: error after update to Arm v1.3 - Update 2

adrianwenger — Fri, 05 May 2017 14:07:46 GMT

Hi,

if i use the version 2.9..., the same error appears:

Re: error after update to Arm v1.3 - Update 2

adrianwenger — Mon, 08 May 2017 09:09:53 GMT

???

Re: error after update to Arm v1.3 - Update 2

martin_kovar — Tue, 09 May 2017 10:55:17 GMT

Hello Adrian,

this is very strange issue. From my point of view, it could be caused by some error during update installation. Could you please try to uninstall the Design Studio including all PEMicro drivers and try it install once again?

Regards,

Martin

PS: which operating system you use?

Re: error after update to Arm v1.3 - Update 2

stanish — Mon, 22 May 2017 21:50:30 GMT

Hello Adrian,

you posted that you are targeting S32K144EVB but your GDB console shows NXP_KEx_S9KEAZ128M4 which is completely different part. This is the reason why flash programming fails - you target MCU and flash programming algorithm must match.

I'd recommend you:

1) create a new project and select the device you are targeting (S32K144).

2) open debug configuration dialog (Menu Run -> Debug Configuration)

3) select the appropriate configuration for your project (typically there are 3 variants for each build configuration - RAM_Debug, Debug, Release), Debug interface (assume you use OpenSDA) and click on "Debug" button

Are you able to run the debug session?

Stan