PowerQUICC ProcessorsのトピックRe: CodeWarrier TAP for PowerQUICC I Probe ?

CodeWarrier TAP for PowerQUICC I Probe ?

mbedardh — Fri, 14 Oct 2022 19:23:17 GMT

I have a CodeWarrior TAP programmer, which is supposed to support the PowerQUICC Processor MPC885, as listed here:

https://www.nxp.com/design/software/development-software/codewarrior-development-tools/run-control-d...

However there is no probe tip suggested for this specific Processor. Which (maybe obsolete) probe Tip should be used ? Or, please provide the complete 30 pins to 10 pins pinout so that i can make a custom probe tip.

Mike

Re: CodeWarrier TAP for PowerQUICC I Probe ?

yipingwang — Mon, 17 Oct 2022 08:33:31 GMT

You need to use USB TAP for PowerQUICC^® I.

Please refer to https://www.nxp.com/design/software/development-software/codewarrior-development-tools/codewarrior-legacy/usb-tap-for-powerquicc-i:USBTAP_PQ1

Re: CodeWarrier TAP for PowerQUICC I Probe ?

mbedardh — Thu, 20 Oct 2022 01:37:58 GMT

Unfortunately this obsolete USB TAP is no longer available. That is why i am hoping that the newer USB TAP would work since MPC885 is listed in its supported devices.

I need a CW TAP probe tip (or a schematics to build it) that would be compatible with MPC8xx processors, its a 10 pins BDM interface identical to the one on page 27 the USB TAP for PowerQUICC I User guide:

https://www.nxp.com/docs/en/user-guide/CWH-UTP-UG.pdf

Thanks

Re: CodeWarrier TAP for PowerQUICC I Probe ?

yipingwang — Fri, 21 Oct 2022 09:20:10 GMT

USB TAP for PowerQUICC^® I is still available.

In addition, you could download CW TAP schematics from

https://www.nxp.com/design/software/development-software/codewarrior-development-tools/run-control-devices/codewarrior-tap:CW_TAP

CW TAP Probe tips schematics from https://www.nxp.com/products/processors-and-microcontrollers/power-architecture/qoriq-communication-processors/p-series/power-architecture-processor-cop-probe-tips-for-codewarrior-tap:CWH-CTP-COP-YE

Re: CodeWarrier TAP for PowerQUICC I Probe ?

mbedardh — Fri, 21 Oct 2022 14:57:15 GMT

The Probe tip you mentionned is not for a 10 pins BDM PowerQUICC I, it is for PowerQUICC II and more. I did not found any, so that is why i am looking at least for a schematics to be able to build a custom one.

Please let me know if there is a probe tip speciffically for the PowerQUICC I ? If not provide a schematics.

Thanks

Re: CodeWarrier TAP for PowerQUICC I Probe ?

yipingwang — Wed, 02 Nov 2022 06:20:08 GMT

Please refer to the following.

https://www.nxp.com.cn/docs/en/application-note/AN2387.pdf