PowerQUICC Processors中的主题 [LX2160ARDB] LED status

[LX2160ARDB] LED status

jhkim2 — Wed, 07 Jul 2021 02:30:09 GMT

Hi,

My LX2160ARDB board cannot boot without any output in UART1.

After power on, M5,M6,M7 leds turn on and turn off sequentially and repeatedly.

Is the LED status is normal?

What condition do those LEDs indicate?

Thanks

JeongHwan Kim

Re: [LX2160ARDB] LED status

ufedor — Wed, 07 Jul 2021 05:07:01 GMT

Which boot source is selected by the SW1[1:4]? (What are positions of the switches?)

Please refer to the QorIQ LX2160A Reference Design Board Getting Started Guide, Table 11. LED array functions.

Please capture video of the LEDs activity.

Re: [LX2160ARDB] LED status

jhkim2 — Wed, 07 Jul 2021 05:34:48 GMT

Hi,

Boot source is XSPI serial NOR (SW1[1:4] = 1111).

I attach the Video captured for LED activity.

Please refer to it.

Thanks

JeongHwan Kim

Re: [LX2160ARDB] LED status

ufedor — Wed, 07 Jul 2021 06:14:17 GMT

According to the QorIQ LX2160A Reference Design Board Getting Started Guide, Table 11. LED array functions and CPLD HDL code the LEDs activity corresponds to "idle" pattern - i.e. no error detected during power-up.

Is CodeWarrior debug connection with the processor possible?

Re: [LX2160ARDB] LED status

jhkim2 — Wed, 07 Jul 2021 06:27:02 GMT

Yes, Codewarrior connection is OK.

I flashed the firmware with codewarrior and tested DDR verification with QCVS in codewarrior.

But I did not find any errors.

Is there any more checkpoint I can test?

Thanks

Re: [LX2160ARDB] LED status

ufedor — Wed, 07 Jul 2021 08:24:09 GMT

Please use a digital scope and check UART1_SOUT signal activity.

Re: [LX2160ARDB] LED status

jhkim2 — Wed, 07 Jul 2021 09:23:37 GMT

Hi,

The RS232 signal is captured by oscilloscope.

But, the signal level is not between +12V ~ -12V.

Then captured signal level is around 0V ~ -6V or -7V.

I attach the captured jpeg file.

Is it the H/W problem?

Thanks

Re: [LX2160ARDB] LED status

ufedor — Wed, 07 Jul 2021 09:49:54 GMT

Please disconnect the UART cable and probe the TXD1_CON again.

Re: [LX2160ARDB] LED status

jhkim2 — Wed, 07 Jul 2021 10:16:12 GMT

UART1 signal is captured after removing RS232 cable at TXD1_CON.

The signal level is the same with that previous captured.

Please refer to attached file.

Thanks.

Re: [LX2160ARDB] LED status

ufedor — Wed, 07 Jul 2021 10:22:17 GMT

The signal does not correspond to the LTC2804 datasheet.

It looks like the LTC2804 was damaged.

Re: [LX2160ARDB] LED status

jhkim2 — Thu, 08 Jul 2021 02:08:51 GMT

I changed the console from UART#1 to UART#2 and message is output from console.

It seems that UART#1 transceiver is broken as you said.

Thank you for help.