topic Re: PE code not being generated in Processor Expert Software

PE code not being generated

Mohsin455 — Wed, 07 Mar 2012 23:48:50 GMT

Hi All,

I am using CodeWarrior for MCU Version: 10.2 (Evaluation Version). I am trying to genrate code for DAC using Processor Expert. I have setup the DAC driver correctly in the PE. When build the bsp_twrk60n512_pe, it does not generate any code (i.e. no new code is being generated in the folder mqx\build\cw10\bsp_twrk53n512_pe\Generated_Code )

What is the procedure to generate the code for newly added Embedded component (i.e. DAC ) ?

Regards,

Mohsin

Re: PE code not being generated

ProcessorExpert — Thu, 08 Mar 2012 17:11:01 GMT

Hello,

I think there are few ways how to generate the code, see below:

1. - Using "Generate Processor Expert Code" menu command from PRoject menu

2 - Using "Generate Processor Expert Code" button on Project panel

3 - Right click on ProcessorExpert.pe node and then use "Generate Processor Expert Code" command from pop-up menu.

Details attached.

best regards
Vojtech Filip
Processor Expert Support Team

Re: PE code not being generated

Mohsin455 — Thu, 08 Mar 2012 17:35:46 GMT

HI,

Yes, I have tried that and I get the following error

Description Resource Path Location Type

ERROR: Selected RTOS adapter driver wasn't found ({PE}\Drivers\sw\RTOSAdaptor\_MQX_RTOSAdaptor.prg) bsp_twrk60n512_pe AD1 Processor Expert Problem

I get same error message for all other components (i.e. DAC, PWM, MQX1 etc)

Regards,

Mohsin

Re: PE code not being generated

ProcessorExpert — Thu, 08 Mar 2012 23:55:19 GMT

Hello,

could you please verify that the file exists on your disk under the path:

{PE}\Drivers\sw\RTOSAdaptor\_MQX_RTOSAdaptor.prg

Could you please specify what verison of CodeWarrior are you using? Could you please download the latest version of Codewarrior and try the same steps there? CW V10.2.

best regards
Vojtech Filip
Processor Expert Support Team

Re: PE code not being generated

Mohsin455 — Fri, 09 Mar 2012 06:04:37 GMT

Hi,

I have checked the following folder

\CW_MCU_v10.2\MCU\ProcessorExpert\Drivers\sw\RTOSAdaptor

and the file is named as MQX_RTOSAdaptor and not _MQX_RTOSAdaptor.

Any specifc reason for this ? If not I will try downloading the latest version as I am presently using CodeWarrior for MCU Version: 10.2 beta (Evaluation Version)

Thanks,

Mohsin

Re: PE code not being generated

ProcessorExpert — Fri, 09 Mar 2012 15:57:04 GMT

Hello,

as far as I know that it should work correctly in the CW V10.2 FINAL.

best regards
Vojtech Filip
Processor Expert Support Team